Products / Stainless & Duplex

TP347 / 347H stainless, columbium-stabilized for creep and welding.

Columbium (niobium) stabilization gives 347 the same intergranular protection as 321 with better weldability and higher creep strength. The H grade is the austenitic superheater tube of choice in high-pressure boilers and refinery heaters.

AlloyTP347 / 347H Stainless Steel
FamilyStainless & Duplex
Supplied toASME SA213, ASTM A213
Typical serviceHigh-temperature service, Superheaters
Size range1/2" to 4" OD, .049" to .250" wall
TempersSolution annealed; 347H with grain size and heat treatment per SA213
Testing100% eddy current or ultrasonic per SA213, hydrostatic, flattening, flaring; grain size, intergranular corrosion, and PMI on request
OriginDomestic and approved import mills, inspected and certified in Hillsboro
Sourced alloy, certified in HillsboroAmeritube does not manufacture TP347 / 347H in Texas. It is supplied from qualified domestic and international mills, then received, inspected, tested, and released under our ISO 9001:2015 system in Hillsboro, Texas, with a full mill test report.

What TP347 / 347H is

Type 347 is 18Cr-10Ni stainless stabilized with columbium and tantalum at roughly ten times the carbon content. Like 321, it resists sensitization in the 800 to 1500 degree F range, but columbium carbides are more stable than titanium carbides, which improves weld-zone corrosion resistance and elevated-temperature strength. TP347H, with controlled carbon and grain size, is the standard austenitic grade for final superheater and reheater tube.

Chemical composition

Element Requirement
Carbon 0.08% max (347); 0.04 to 0.10% (347H)
Chromium 17.0 to 19.0%
Nickel 9.0 to 13.0%
Columbium + Tantalum 10 x C min to 1.10% max (347); 8 x C min (347H)
Manganese 2.00% max

Mechanical properties

Property Minimum
Tensile strength 75,000 psi (515 MPa)
Yield strength 30,000 psi (205 MPa)
Elongation in 2" 35%

Where it is used

  • Final superheater and reheater tube in utility boilers.
  • Refinery heater radiant and convection tubes, FCC and coker units.
  • High-temperature hydrogen and hydrocarbon service.
  • Chemical plant furnace tubes and heat exchangers above 1000 degrees F.

Ordering note

347H for pressure parts under ASME Section I requires specific heat treatment and grain size. Send the design code and temperature and we will make sure the certification covers it.

What to put in your TP347 / 347H RFQ

347 or 347H, OD, minimum wall, length, quantity, design temperature, grain size, and the ASME Section or licensor specification. Mention any stabilizing anneal or shot-peening requirement.

Documents

Related alloys

Industries